Why does autotest sometimes re-run all specs immediately after a failure?
-
27-10-2019 - |
سؤال
Sometimes after autotest runs specs and encounters an failure, it will immediately re-run all the specs in the project, which (a) I have no need for and (b) clears the terminal so I can't read the results of the failed spec.
Why is this happening?
المحلول
This can happen for a number of reasons:
- A file was touched that is not in the ignore list or has a mapping.
- Autotest could not parse your test output for fail state and assumed that walking back up the failure tree is reasonable.
- Your tests sent an interrupt to autotest.
لا تنتمي إلى StackOverflow