Assembly wrong result of exponent power procedure

Question

This was a 2 part assignment. first I had to figure out how to send a reference parameter to a procedure called pow using the stack which I think I did correctly using push offset result The second part of this assignment has me completely clueless, i've read and read in my text but I am still unable to figure out how I can accomplish what I need to do. After sending the reference parameter I need to make the result of the calculations in the pow procedure become stored in the reference parameter so it can be output later in the program. I've tried a few different things so far to no avail. The code is commented so those familiar with assembly should understand what i'm trying to do. If anyone could help me out I will greatly appreciate it. thanks

INCLUDE Irvine32.inc
.data
XPrompt BYTE "Enter the value of the base(X):",0
YPrompt BYTE "Enter the value of the exponent(Y):",0
ResultMessage BYTE "X to the power of Y is",0
result DWORD ?

.code
main PROC
    call Clrscr

   ;;;;Prompt for X 
    mov  edx,OFFSET XPrompt
    call WriteString

    call ReadInt
    push eax     ;;;;pass the 1st number to POW
                 ;;;;this will represent the base

   ;;;; Prompt for Y 
    mov  edx,OFFSET YPrompt
    call WriteString

    call ReadInt
    push eax            ;;;;pass the 2nd number to POW
                        ;;;;this will represent the EXPONENT

    push OFFSET result  ;;;;pass the third parameter to pow, using offset makes it a reference parameter                         

    call Pow
                             ;;; Print Result (Assumes the answer is in eax)
    mov  edx,OFFSET ResultMessage
    call WriteString

    ;;;;;;;;;;;;;;;;;NOTE: NEW "POW" MODIFICATIONS HERE;;;;;;;;;;;;;;;;;;;;;;;;;;;;
    mov eax,result     ; If the pow function correctly returns it answer by reference
                       ; then this should be all that's necessary to print
                       ; the answer with the call to "WriteInt"
   ;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;                     
    call WriteInt
    call ReadInt             ;;;; screen pause
    exit
main ENDP

;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;
Pow PROC
COMMENT !
PUT FUNCTION CODE IN THIS SECTION

This current  pow function returns its answer via register "eax." Modify it as necessary
so that it returns its answer by a reference parameter. In C++ the function interface/prototype
would look like:

 void pow(int base,int exp, int & result)

where "base" is the base and "exp" is the exponent. In other words "pow" should calculate "base" to the
power of "exp," then return the answer via "result."  Let your function return its result via a
3rd REFERENCE parameter "result." Which will be a REFERENCE parameter on the stack. 
 !

 base EQU DWORD PTR [ebp + 12]
 exponent  EQU DWORD PTR [ebp + 8]

 push ebp
 mov ebp, esp
 push ecx  ;<------------ecx must also be preserved since it is modified
           ; by the "loop" instruction.

 mov ecx, exponent ;set ecx as our counter
 mov eax, 1        ; eax will be our multiplier
 L1:
  mul base
  loop L1

pop ecx  ;<------------restore ecx
pop ebp  ;<------------restore ebp

ret 8
Pow ENDP
END main