Using gdb in Emacs 23

Question

I am trying to move from Emacs v22.3.1 to v23.1.1 and all was going well until I tried to run gdb using gud inside Emacs.

When I do meta-x gdb and give a command of 'gdb /my/executable/here' the window comes up fine, but when I type a command at the gdb prompt upon hitting return key to execute the command, nothing happens, status bar says 'Debugger:run' and the result is never shown. I can type 'ctrl-c ctrl-c' to kill the command and get the '(gdb)' prompt again, but another command just fails the same way.

This is gdb v6.8 on Linux Centos v4 32bit.

Has anyone else faced this issue? What is the best way to proceed?

I attached to gdb from a prompt (not gud) and got this stack trace:

#0  0x00fd77a2 in _dl_sysinfo_int80 () from /lib/ld-linux.so.2
#1  0x0020108d in poll () from /lib/tls/libc.so.6
#2  0x08111a07 in gdb_do_one_event (data=0x0) at event-loop.c:759
#3  0x0810f05f in catch_errors (func=0x8111970 <gdb_do_one_event>, func_args=0x0, errstring=0x8236200 "", mask=6) at exceptions.c:513
#4  0x080c25e7 in tui_command_loop (data=0x0) at .././gdb/tui/tui-interp.c:153
#5  0x0810f2cf in current_interp_command_loop () at interps.c:276
#6  0x0807f0b3 in captured_command_loop (data=0x0) at .././gdb/main.c:99
#7  0x0810f05f in catch_errors (func=0x807f0a8 <captured_command_loop>, func_args=0x0, errstring=0x8236200 "", mask=6) at exceptions.c:513
#8  0x0807f7eb in captured_main (data=0xbff00a60) at .././gdb/main.c:882
#9  0x0810f05f in catch_errors (func=0x807f0e0 <captured_main>, func_args=0xbff00a60, errstring=0x8236200 "", mask=6) at exceptions.c:513
#10 0x08080027 in gdb_main (args=0x7fffffff) at .././gdb/main.c:891
#11 0x0807f0a1 in main (argc=-4, argv=0xfffffffc) at gdb.c:33
#12 0x00153df3 in __libc_start_main () from /lib/tls/libc.so.6
#13 0x0807efdd in _start ()

Answer 1

Here's a wild guess:

Emacs's gud-mode requires that gdb gets run with annotations turned on so that it can properly parse the output. I've been bit by this when rewriting the default line emacs spits out after hitting M-x gdb. Make sure that "--annotate=3" is included on your gdb command line and see if that helps.

Answer 2

I have used gdb in emacs-23... Or at least, I've gotten farther than you... When I tried it, the stack window wouldn't update... What I ended up doing was using emacs-23 for editing (for the anti-aliased font goodness), but using emacs-22 for debugging... You can have both installed...