tell gdb to disassemble “unknown” code
-
22-09-2019 - |
Question
is it possible to configure gdb in order to debug assembly code when there are no debug symbols or no sources available ? I mean showing assembly instruction by assembly instruction when performing a step by step debug (next /step commands) (not desassembling all the function. just the next instruction that will be executed)
Regards, Ayman
Solution
set disassemble-next-line auto
Is what I find most useful. You can also set it to "on" to disassemble even if source is available.
OTHER TIPS
Yes. Use display/ni $pc
to disassemble the next n
instructions.
Also, download the GDB manual.
Licensed under: CC-BY-SA with attribution
Not affiliated with StackOverflow