D
is to define a single data. You can go to the first instruction and use U
for Undefine
. It will remove more code than "Convert to data".
Convert large amount of code to data in IDA
-
17-01-2022 - |
Question
Well, Unfortunately I hit 'C' on a data section of a binary i had worked a lot on and saved it as i had a lot of work unsaved. I tried converting this huge section back to data but whenever i select lines and press 'D', only the line where the cursor was gets converted to data.
So, My question is, How do i mark/convert a large amount of data to code in IDA (specifically 6.1)
(The target architecture is ARM if that matters).
Solution 2
OTHER TIPS
You could do it with a quick IDAPython script, e.g. enter:
for a in xrange(startaddr, endaddr): MakeCode(a)
into the 'Python' field of the Output window.
Licensed under: CC-BY-SA with attribution
Not affiliated with StackOverflow