adjusting the baud-rate of pic24

StackOverflow https://stackoverflow.com/questions/17048293

  •  31-05-2022
  •  | 
  •  

Question

i have a device outputting an data with 19200 baud. The pic has been configured with SPBRG=12 BRGH=0 start and stop bits have been taken into account.

Nevertheless the pic doesn't receive the correct data! The data sent has been verified with hyper terminal and oscilloscope.

i can't find the error! Damn any help?

Thx

Was it helpful?

Solution

Besides the electrical, on some versions of PIC24 (actually I use dsPIC33, but they are much the same) there is also peripheral pin select to deal with. I also set TRIS appropriately, but I think that is not necessary.

Licensed under: CC-BY-SA with attribution
Not affiliated with StackOverflow
scroll top